Japanese Garden Lantern

Japanese garden lanterns in traditional Japanese wooden lantern style,
hand made with care in the UK in
preservative treated oak timber.

Japanese Style logo
















wall lantern

Wood Slatted Roof
 
Profiled oak slats form the tiles on this more impressive style of roof.

£74.50 complete with lamp & power adaptor

For P&P cost please contact

wall lantern





wall lantern

Gable Sided Roof
 
A very traditional style of lantern roof, a flat board roof with curved gable ends.

£62.50 complete with lamp & power adaptor

For P&P cost please contact

wall lantern





WALL LANTERNS

Easy to install low voltage accent lighting.

The bottom of the wall lanterns are open, serving two purposes:
  Easy lamp replacement.
  Light spill directly below, to illuminate a pathway.

Each lantern comes complete with lamp and power adaptor (see Note below).

Relevant instructions and hints & tips on installation will be included.

CONSTRUCTION

All made from oak and dip treated in preservative which has a wax additive to help water shedding.

All metal components (pins, nails, screws) are all solid brass, no plated steel.

100% water resistant adhesives used throughout.

The windows are UV protected polycarbonate. The inside surfaces are sanded to diffuse light and then protected with a tough lacquer.

ELECTRICAL

Lamp holders are ceramic E27 (screw fit), and unlikely to break with age like some plastic lamp holders.

12v 5w CFL (Compact Fluorescent Lamp) warm white (2700K), E27 screw fit.

Plug-in power adaptor, 12v 2Amp (switch mode type).

NOTES

If purchasing more than one lantern, it should be noted that one power adaptor is adequate for supplying two 12v 5w CFL (but no higher rated lamps).
Higher power CFLs (up to 12v 15w) can be fitted in the lanterns but then a power adaptor for each will be needed.

The lamp holder in the lantern is pre-wired to a connector block, and the power adaptor also has a connector block fitted to its lead. You will also need to obtain a length of cable to join between these. This cable cannot be included as part of the kit because the length required is an unknown factor. However this can also be supplied, please see Cabling/Connection in the Terms page.





wall lantern

Slate Tiled Roof
 
Natural slate tiled roof.

£74.50 complete with lamp & power adaptor

For P&P cost please contact

wall lantern




Copyright ©2011 John A R Markham - All rights reserved